Specialists tooling and handling equipment
We offer tooling design as part of “Rig Design & Make” scope or as a support package for Test vehicles at customer
Test facility and utilises in-house design standards and guidelines or if desired, can work to any customer Standard upon request.
- SPTE (Special to Test Equipment) Design Consultancy
- SPTE Design in Detail
- Component Definitions, Tooling Schemes, Assembly Instructions, Design Reports
- Manufacturing and assembly of SPTE hardware
E.g. test-, build-& transportation-stands, service lines, assembly tooling, lifting equipment.
Our Capabilities
- Requirements and compliance management, Risk assessment
- Validation strategy
- Rapid 3D design:
- Support structures for operation, build and/or transportation
- Test vehicle & drive shaft adaptation to existing testbed structures
- Service line adaptation and routing
- Assembly and installation aids, jacking tooling and lifting equipment
- FFMEA & DFMEA, Robust Design principles, Systems Engineering
- 3D detail design, 3D routing (optional), Limited Dimension Definition
- Design to Manufacture, Design to Cost, Manufacturing Technology development
- Design for Assembly sequence
Software Tools
- Siemens NX (default standard)
- Catia V5
- Solid Works
